|
|
Post by aquamac on Apr 14, 2012 7:31:56 GMT
Hi Eelhead, must have mised this one, the IO panel was made from 4 pieces. There is a front plate with the hole cut out, the IO part which is folded up at either side then a top and bottom cap. These were spot welded to each other then cleaned up.
|
|
|
|
Post by eelhead on Apr 15, 2012 15:08:37 GMT
Hi Eelhead, must have mised this one, the IO panel was made from 4 pieces. There is a front plate with the hole cut out, the IO part which is folded up at either side then a top and bottom cap. These were spot welded to each other then cleaned up. Thanks for the reply! Yeah I was thinking it was several. I like the design so I was thinking of implementing that into mine. Got the mATX board and kinda just going to take my time with it. Thanks again and thanks for the modding ideas ! |
|
