vaz
Junior Member
Posts: 65
|
Post by vaz on Jun 11, 2007 1:45:40 GMT
I lost my bookmark but there was a good site where a guy took apart his motherboard showing every single screw to remove and highlighted it red. Its not the ones mentions on here, but if anyone has the link or has photos of all the screws (and count number), please post them up here.
Thanks
|
|
vaz
Junior Member
Posts: 65
|
Post by vaz on Jun 20, 2007 7:02:21 GMT
|
|
|
Post by aquamac on Jun 20, 2007 12:06:49 GMT
|
|
|
Post by B B on Jun 20, 2007 15:45:19 GMT
|
|
|
Post by B B on Jun 21, 2007 19:43:47 GMT
I lost my bookmark but there was a good site where a guy took apart his motherboard showing every single screw to remove and highlighted it red. Its not the ones mentions on here, but if anyone has the link or has photos of all the screws (and count number), please post them up here. Thanks I realize that I did not carefully read your topic. There is only one screw to secure the MOBO, because the Motherboard is maintained on the metallic plate with some metallic stiks. Now the screws which maintain the Daugther Bord with the processor(s), attache in the same time the MOBO. I will picture the plate I am using with my mod to show you. I hope it will help.
|
|
vaz
Junior Member
Posts: 65
|
Post by vaz on Jun 21, 2007 20:28:49 GMT
Ahh okay thats good to know! I see the 1 screw too, and then the daughtercard screws too. Apparently there's very high success rate with this mod and if the motherboard does get unstable, i can fill the resistor back with a wad of foil Wish me luck!
|
|