|
Post by johnson on Jun 18, 2011 21:28:57 GMT
Hello, I just mis-flashed a sapphere X800XT AGP 8x, the Mac ROM is fine, as the system boots up blind, and via VNC I can see the card being 'read':
pci1002,4a48:
Type: Display Bus: AGP Slot: SLOT-1 Vendor: ATI (0x1002) Device ID: 0x4a48 Revision ID: 0x0000
But the thing is supposed to be: pci1002,4a50 as 4A50 was the origonal DID according to atiflash from DOS.
The FCode is definitly in there, but just no video. BIOS (PC) no longer boots with the card, so I can't reflash it from DOS. I hexxed the mac rom afterwards (as soon as I saw my mistake) so the DID is correct (on 3 and the other line), but how to flash this? Graphiccelerator 1.3.4 has the Multiflasher, but even in safemode it won't flash (via VNC). The system hosting the x800xt is my G5 DP 2.0Ghz, with the molex plugged in as well, to provide the power. (so that's not the issue)
When I load the ROM into the Flasher (using Graphiccelerator) and execute the flasher, it asks for confirmation, but gives an error when I accept.
Is there a different flasher out there?
Something different: I have a dead 9800 PRO with a nice 128kb rom on it (same smd package and pins), which in theory would allow me to move it over to the x800xt and use a full mac rom, right? Would that give me DVI as well? The GPU on the x800xt board is a R420, which is quite close to the firegl series that support DVI after flash.
|
|
|
Post by destroya01 on Apr 27, 2012 22:16:24 GMT
I got a similar problem. What your looking for is the no-confirmation flasher aquamac talks about in his posts. He even says it's linked on this forum, so I'm currently searching for it. If I find it I'll make sure to give you a heads up.
|
|
|
Post by aquamac on Apr 29, 2012 18:17:21 GMT
I have searched for this but as yet, i have been unable to find it. If i do, i will post back here.
|
|